LAARS NeoTherm NTV (Sizes 150–285 MBTU/h) - Service Manual - Manual (Page 47)

37 Service Manual NeoTherm 80 - NeoTherm 285
The easiest way to remove the blower is to remove the air/gas channel
and blower as an assembly, then separate the blower from the assembly.
Because of the way the blower is mounted in the machine, it would be
very difficult to remove the blower from the machine directly.
Figure B19-1 shows how the parts are arranged.
Gas valve
Rubber inlet
hose
Air/gas
channel
Blower
Fig. B19-1 - Blower and other parts
Tools and equipment required:
• 3 mm and 4 mm Allen wrenches (tra-
ditional “L” shaped, ball-head is best)
• #25 Torx® driver
• Gas-resistant pipe dope or Teflon®
tape
• Gas leak detection solution (i.e. Her-
cules Megabubble®)
• Container for removed parts
Procedure:
1. Turn off power to the machine. Use the main dis-
connect switch on the front of the machine, just
above the control panel.
2. Remove the front panel.
3. Shut off the gas at the gas shutoff valve on the
right side of the machine (yellow handle). See
Fig. B19-2.
Fig. B19-2 - Gas shutoff valve (typical)
Removing and Replacing the Blower
B19