Interlogix XL LCD Keypad Plus Regional Settings Guide - Manual (Page 70)

xL Regional Settings Guide 21-3609E rev1.0 66
France □ (no)
N America □ (no)
European □ (no)
U.K. ACPO □ (no)
Aus/NZ □ (no)
China/H.K. □ (no)
Netherlands □ (no)
Switzerland
□ (no)
Hold PIN Prompt 9
(yes) □ (no)
Personal access device (card,
fob) must be held at e.g. keypad
reader and a PIN must be
entered for a response.
France □ (no)
N America □ (no)
European □ (no)
U.K. ACPO □ (no)
Aus/NZ □ (no)
China/H.K. □ (no)
Netherlands □ (no)
Switzerland
□ (no)
Disable Single on
Badge-Hold 9
(yes) □ (no)
This determines whether or not
the action defined under 'single'
(in or out of schedule) will also
occur on a badge-hold action.
Not selected: Badge-hold
produces action defined under
'single' is included.
Selected: Badge-hold action
occurs by itself.
France □ (no)
N America □ (no)
European □ (no)
U.K. ACPO □ (no)
Aus/NZ □ (no)
China/H.K. □ (no)
Netherlands □ (no)
Switzerland
□ (no)
Disarm Card + PIN 9
(yes) □ (no)
Must also use PIN to turn
protection off after using access
device (card, fob) at keypad with
internal reader.
France □ (no)
M0xx È07 Keypad Selections NOTE: “xx” represents the module number.
WARNING: These Access Control features are only available with the addition of the “Feature Expansion Board”.
(left to right on keypad screen) N America Example:
Pressing the keypad button under È ? will display the type of module and the module’s input and output ranges.
Name Selections Description Regional Settings Default
Reader Defined 9
(yes) □ (no)
† (no)
Card Lockout
Schedule 00 = No scheduled lockout
01 – 250 Schedule A schedule to specify when card
access will be blocked 000
Enable or Disable
Cards of Type 0 = None
1=Escort Req’d, 2 =non-
permanent users. 3 =all users 0
Enable or Disable
Mode If enabling reader, see Note *1.
If disabling reader, see Note *2. Note *1: If enabling reader,
0=enable for 4 hrs, 1=enable for
8hrs, 2=enable for 12 hrs,
3=enable for 24 hrs, 4=enable
for 1 week, 5=enable until
midnight tonight, 6=enable
permanently, 7=enable until out
of schedule according to
schedule 50.
Note *2: If disabling reader,
0=disable card permanently,
1=disable card but set it so that
it can be re-enabled later at an
enabling station, 2= disable card
permanently and trigger auxiliary
output , 3= disable card enable
re-enroll and trigger auxiliary
output, 4 to 7 = not used, same
as 1 (room for future expansion) 0
NOTE: Programming selections whose boxes are grey are not available for this version.
†
· 000 · 0 · 0 ·
†††
···
È Save È ? M001 И 07