Great Planes ESP6 Easy Sport 60 - GPMA0152 - Manual (Page 35)

D 14. Press the middle fuse top into place between the
fuse sides. Glue the middle fuse top to only the fuse sides.
NOTE: make sure that no glue gets into the joint
between the middle fuse top and the aft fuse top.
EASY SPORT .40 HATCH
EASY SPORT .60 HATCH
D 15. Center the fuel tank hatch in its opening and
tape in place. Drill a 1/16" hole at each of the five
locations shown in the sketch. Remove the hatch and
enlarge the holes in only the hatch to 3/32". Secure the
hatch with five #2 x 3/8" sheet metal screws, but do not
overtighten the screws.
D 16. Starting with coarse (80-grit) sandpaper and
finishing with fine (220-grit), round off all corners and
edges of the fuselage. Remember to blend the excess
nose block material flush with the fuse sides.
NOTE: Do not sand off the marks made with the felt-tip
marker in step #13.
D 1. Using a felt-tip pen, draw a line from the seam
between the middle fuse top and the aft fuse top to the
marked pin exit on the fuse side. Draw a line from the
marked pin exit to the bottom trailing edge of the wing
cutout. Finally, draw a line from the seam between the
middle fuse top and the hatch to the front edge of the
wing opening.
35