Great Planes ESP6 Easy Sport 60 - GPMA0152 - Manual (Page 30)

D 2 Test fit, but do not glue, the firewall/tank floor
assembly between the fuse sides The rear tab of the
tank floor should fit into the notch in F2 and set on the
ledge created by the fuse doublers The firewall should
fit in the notches in the fuse doublers After you have
checked the fit, glue the firewall to the fuse sides with
30-minute epoxy Important: Make sure the tank floor is
positioned correctly Once the firewall is glued in, the
tank floor cannot be removed Clamp the fuse sides
against the firewall with rubber bands or masking tape
until the epoxy cures After the epoxy cures, glue the
tank floor to F2, the firewall and the fuse doublers with
medium CA.
D 3 Trial fit the laminated wing mounting block into the
notches in the fuse doublers and F3 Sand if necessary
to achieve a good fit Glue the wing mounting block to
the fuse sides, fuse doublers and F3 with 6-minute
epoxy Make sure the wing mounting block is tight
against the fuse doublers and F3.
D 1. Depending on the landing gear configuration, test
fit, but do not glue, the grooved hardwood landing gear
(LG) rail in the notches in the bottom fuse doubler The
aft notches are for the tricycle landing gear The forward
notches are for a taildragger The landing gear rail
should fit snugly in the notches and between the fuse
sides.
30