Great Planes ESP6 Easy Sport 60 - GPMA0152 User Manual
Page 32
NOTE: You must refer to the proper version in these
sketches as you install the pushrod tubes.
The following instruction photos apply to the
installation of a 2-stroke engine with a tricycle
landing gear.
D 1. Locate the two 36" outer pushrod guide tubes
and scuff the outsides with fine (220 grit) sandpaper.
Working from the open fuse bottom, route the tubes
through the F5, F4 and F3 formers as shown. Make sure
that both pushrod guides extend 1" as shown. The tubes
must also protrude at least 1" from the fuse side exits.
Securely glue both pushrod guides to each former and
fuse side with medium CA. Finish the tubes at the fuse
side exits (procedure described below). Save the excess
lengths of outer tube.
D 2. Using the excess outer pushrod guide tube material
from the previous step, install the throttle and nosewheel
steering guide tubes as shown. The nosewheel guide
should be flush with the firewall and the throttle guide
should protrude 1/8" to 1/4" from the firewall. Refer to the
pushrod layout diagram for the version you are building.
32