Great Planes ESP6 Easy Sport 60 - GPMA0152 - Manual (Page 33)

Bevel top and bottom of F3A
as shown. Not shown to scale.
D 3. Locate former F3A and bevel the top and bottom
to the profile shown in the sketch. Then, glue in place
with medium CA as shown.
D 2. Locate the two die-cut 1/8" balsa forward fuse
bottom halves and glue together in the same manner as
step #1.
D 3. Locate the two die-cut 1/8" balsa middle fuse top
halves and glue together in the same manner as step #1.
D 4. Test-fit the main fuse bottom into place between
the fuse sides. Sand the edges, if necessary, for a good
fit. Apply thick CA to the edges of the main fuse bottom
and the bottom of formers F3 and F4. Press the main
fuse bottom in place, making sure that F3 and F4 key
into their slots.
D 1. Locate the two die-cut 1/8" balsa aft fuse bottom
halves and the two die-cut 1/8" balsa middle fuse
bottom halves. Sand the edges slightly until they fit
together properly. Working directly over the plan top view
(covered with waxed paper), glue the four parts together
with thin CA to form the main fuse bottom. Remove the
main fuse bottom from the plans and inspect the glue
joints for gaps, adding thick CA glue if necessary. Sand
the glue joints smooth on both sides with an Easy-Touch
bar sander and 150-grit sandpaper.
D 5. Carefully measure and cut the forward fuse
bottom as shown. Keep the small center portion from
the Easy Sport 60 forward fuse bottom to use as filler
in step 10.
33