beautypg.com

Gyro – Futaba 14MZ User Manual

Page 99

background image

●Return to Model Menu

Gyro

[Corresponding model type]: Airplane/glider, general

This function is used when a GYA Series gyro

is used to stabilize the fuselage attitude. The
sensitivity and operation mode (Normal mode/GY
mode) can be switched with a switch.

● Three rates (Rate 1/Rate 2/Rate 3) can be

switched.

● Up to 3 axes (Gyro/Gyro 2/Gyro 3) can be

simultaneously controlled.

*Initial setting does not assign a sensitivity channel. Use the

● Touch the [Gyro] button in the Model Menu

to call the setup screen shown below.

Function menu of the Linkage Menu to assign the sensitivity
channel (Gyro/Gyro2/Gyro3) used to a vacant channel
beforehand.

Set [ACT] and [Trim] other than Function to [NULL].

● The operation mode (AVCS/NOR) and sensitivity of

the 3 axes Gyro/Gyro2/Gyro3 can be set.

● Group/single mode switching

(Gr./Sngl)

(For more information, see the description

at the back of this manual.)

● Three rates (Rate 1/Rate 2/Rate 3) can be used.
● Touch the ACT button of the rate to be used, and set the function to

ACT ([ON] or [OFF]).

● When a Futaba GYA gyro is used, when [GY] type is s elected, the

sensitivity set value is directly read in both the AVCS and NOR modes.

● When setting a switch, touch the switch button to call the

screen, and then select the switch and set its ON direction.

(For a description of the switch selection method, see the description at

the end of this manual.)

(Example) Setting 3 axes using a GYA351 and GYA352 (2 axes gyro)

● Wing type: Aileron 2 servos mounted fuselage selected
● Set Gyro 1 (GYA351): CH7, Gyro 2 (GYA352): CH8, Gyro 3 (GYA352): CH9 at the

Function menu of the Linkage Menu.

● Rate 1 [OFF][GY][SW-E][NOR][60%][NOR][60%][NOR][60&][Gr]
Rate 2 [INH][GY][NULL][AVCS][0%][AVCS][0%][AVCS][0%][Gr]
Rate 3 [OFF][GY][SE-E][AVCS][60%][AVCS][60%][AVCS][60%][Gr]

*When separating the conditions, set to [Sngl].
*Set so that Rate 1 is turned on at the back position of switch E and Rate 3 is turned ON at the

front position.

Since switch E is turned OFF at the center, Rate 2 remains [INH].

99