Futaba 14MZ - Manual (Page 20)

Installing and Removing of the battery
LT2F2200 for the transmitter
Attachment of the battery
1. Hook one of your fi ngers in the slit formed by
the transmitter’s main body and the battery
cover on the bottom of the transmitter, and
then pull up the cover to release the lock.
You can now open the cover in the direction
of the arrow.
2. Move the slide lever to the right end, and
then install the battery in the holder.
● Move the slide lever to the far right.
3. Push the battery to the left with your fi nger.
4. Close and lock the battery cover until you
hear a snapping sound.
Removing of the battery
Note: If you detach the battery while the
power is on, the data you have set will not be
saved.
1. Hook one of your fingers in the slit formed
by the transmitter’s main body and the
battery cover on the back and bottom of
the transmitter, and then pull up the cover
to release the lock. You can now open the
cover in the direction of the arrow.
2. Slide the slide lever to the right while pressing
it, the battery will be released.
Warning
Be careful to not drop the battery.
Never take out the battery from the T14MZ
transmitter while the LED monitor is blinking
yellow after turning off the power the T14MZ
transmitter.
* Internal devices such as memories may have been de-
stroyed.
* If there is any problem, the message "Backup Error" will
be shown the next time when you turn on the power of the
transmitter. Do not use the transmitter as it is, send it back
for a check to the Futaba Service Center.
20