Futaba 14MZ - Manual (Page 86)

RUDDER 2
RUDDER RUDDER
V-TAIL
RUDDER 2
Winglet
RUDDER 1
Winglet
at Flying wing at Flying wing
( ) ( )
AIL 3 AIL 3
(Chip Aileron) (Chip Aileron)
AIL1
(Main Aileron)
AIL 2
(Main Aileron)
●Return to Model Menu
AIL to RUD [Corresponding model type]: Airplane/glider, general
Use this mixing when you want to mix the
rudders with aileron operation.
● A mixing curve can be set.
● Mixing during fl ight can be turned ON/OFF by
setting a switch. (Always ON at NULL setting)
● The mixing rate can be fi ne-tuned by setting a VR.
● Touch the [AIL to RUD] button in the Model
Menu to call the setup screen shown below.
*The display screen is an example. The actual screen depends
on the model.
● Mixing curve setting
(For a description of the curve setting method, see the
description at the back of this manual.)
● Fine tuning VR setting
●Group/single mode setting (Gr./Sngl)
(For more information, see the description at the
back of this manual.)
● Left/right overall
a d j u s t m e n t b y
Rate A and Rate B
Setting method
● Touch the ACT button and set the function to ACT
(ON).
● When setting a switch, touch the [NULL] button of
the switch to call the screen, and then
select the switch and set its ON direction. (Always
ON at "NULL" setting)
(For a description of the switch selection method,
see the description at the back of this manual.)
● When setting a VR, touch the Fine Tuning "NULL"
button to call the screen, and then
select the VR. The adjustment rate and direction
can be set. The VR operation mode can also be
selected.
● A mixing curve can be set.
(For a description of the curve setting method, see
the description at the back of this manual.)
● The curve display mode can be changed.
Single : Displays the mixing curve only
Fine tuning : Displays the mixing rate of the fi ne
tuning VR
All Cond. : Displays the mixing curve of all the
conditions. (When conditions are set)
●Curve display mode selection (Single/Fine tuning/All Cond.)
Fine tuning VR setting
Mixing rate 0% at center of VR
When the VR is turned counterclockwise
and clockwise, the mixing rate increases
and decreases, respectively.
Mixing rate 0% at left end of VR
When the VR is turned, the mixing rate
increases.
Mixing rate 0% at right end of VR.
When the VR is turned, the mixing rate
increases.
When the VR is turned to the left or right
of the neutral position, the mixing rate
increases.
● VR selection ● Rate adjustment
● Operation mode selection
*Displayed at VR setting.
● Adjustment direction
setting
[Operation modes]
86