Futaba 14MZ - Manual (Page 15)

●Projection
2. Disconnect the connectors of switches you
want to change.
3. Use the attached jig (inside stylus) to turn the
face nuts counterclockwise, this will detach
the switches.
4. To re-attach, use the face nuts to attach
switches from other positions or optional
switches to the switch block.
5. Connect your connectors.
6. Insert the switch block so that it fi ts correctly
into the body of the transmitter (as shown in
the picture) and use the hexagonal wrench
to tighten the screws.
Volume
● Locked state
Volume LD, CD, and RD:
If you push the volume to the bottom, the volume
will stay there. If you push the volume again, the
lock will be released and become operative again.
This volume is digital type (rotary encoder). This
volume works as both a volume and a push-switch.
*T14MZ beeps when the volume knob reaches center.
*You can check the volume position on the Dial Monitor
screen in the Linkage menu.
*You can use each setting screen of the mixing functions to
select volumes and defi ne the direction of its movement.
Slide Lever
●LST
●LS ●LS
LST (Left), RST (right):
Outside levers
LS (Left), RS (right):
Inside levers: Each lever has two ends, one in
front and the other on the back.
*It sounds when the lever comes to the center.
*You can check the lever position on the dial-monitor screen
in the linkage menu.
*You can select a slide lever and set the movement direction
on the setting screen of mixing functions.
15