Camber mix, Ele to camber, Camber flp to ele – Futaba 14MZ User Manual
Page 81: Butterfl y (crow), Trim mix 1/2, Airbrake, Gyro, V-tail, Ailevator, Winglet
![background image](/manuals/676331/81/background.png)
AIR BRAKE
AIL 3
(Chip Aileron)
AIL 4
(Chip Aileron)
AIL1
(Main Aileron)
AIL 2
(Main Aileron)
FLP 2
(Camber Flap)
FLP 1
(Camber Flap)
ELEVATOR
(ELEVATOR 2)
V-TAIL
FLP 3
(Brake Flap)
FLP 4
(Brake Flap)
RUDDER 2
Winglet
RUDDER 1
RUDDER
(RUDDER 2)
Winglet
at Flying wing
at Flying wing
( )
( )
ELEVATOR
ELEVATOR 2
(AILERON 6)
●Camber Mix
This mixing adjusts the camber and corrects the
elevators. [Airplane/glider, 2 ailerons or more]
●ELE to Camber
This mixing is used when you want to the mix
camber fl aps with elevator operation. Lifting force
can be increased at elevators up. [Airplane/glider,
2 ailerons or more]
●Camber FLP to ELE
This mixing is used to correct for attitude changes
when the camber fl aps are being used. [Airplane/
glider, 2 ailerons + 1 fl ap or more]
●Butterfl y (Crow)
This function is used when powerful brake operation
is necessary. [Glider, 2 ailerons or more]
●Trim Mix 1/2
The ailerons, elevators, and fl aps trim offset rate can
be called by switch or condition selection. [Glider, 2
ailerons or more]
●Airbrake
This function is used when airbrakes are necessary
when landing or when diving, etc. during fl ight.
(Airplane, general)
●Gyro
This is dedicated mixing when a GYA Series gyro is
used. [Airplane/glider, general]
●V-tail
This function adjusts the elevators and rudder of
V-tail models. [Airplane/glider, V-tail specifi cations]
●Ailevator
This function adjusts the elevators and ailerons of
models with elevator specifi cations. [Airplane/
glider, elevator specifi cations]
●Winglet
This function adjusts the left and right rudders
of winglet models. [Airplane/glider, winglet
specifi cations]
●Motor
The operation speed when the motor of F5B and
other EP gliders is started by switch can be set. [EP
glider, general]
●RUD to ELE
This function is used to correct roll maneuvers, knife
edge, etc. of stunt planes. [Airplane, general]
●Snap roll
This function selects the snap roll switch and adjusts
the steering angle of each rudder. Servo speed can
also be adjusted. [Airplane general]
●Multi Engine
This function adjusts the throttles independently
when using a multi engine model. (Maximum 4
engines) [Airplane, general]
81
(AILERON 5)
AILEVATOR