Futaba 14MZ - Manual (Page 109)

Normal Curve Idle-up 1 Curve Idle-up 2 Curve Hold Curve
●Pitch Curve (Example)
● Group button: When you also want to input the
same setting contents at other conditions, perform
setting in the group mode (initial setting). In this
case, the same contents are input to the other
conditions set in the group mode. When you
want to set each condition independently, select
the single mode. Other conditions can be set
independently.
● Normal % input or angle input can be selected at
rate adjustment at curve setting. For angle input,
if the high side, low side, and center angles are
input beforehand, the rate can be set by reading
the angle directly (standard).
● The curve graph display mode can be selected.
This is convenient when checking curves other
than the curve currently being set.
[Sngl]: Displays only the curve currently being set
Setting method
[Fine Tuning]: When pitch trim is used, a curve with
pitch trim adjustment added is also displayed.
[All Cond.]: Displays the pitch curve of all the
conditions. The curve of the condition currently in
use is indicated by a bold line.
PIT&THR: The throttle hold curve of the condition
currently in use is also displayed.
● The Throttle Curve setup screen can be called
with one touch, which is convenient when making
adjustments alternately with the throttle curve.
● The servo operation speed can be set. When
adjusted when the pitch is too sensitive, the pitch
operation feeling can be changed.
● When increasing the number of points, use the
cursor keys [<][>] to move the cursor to the point
where you want to enter a point ( ) and touch
the Rate button. The point is created.
The screens shown below are curves created by
entering the pitch angle at low, center, and high side
3 points or 5 points at each condition. They were
created by reducing the number of points to the
3 points of low side, center, and high side. When
actually creating a curve, input the angle specifi ed
at the fuselage (or the reference value).
*For a description of the curve setting method, see the
description at the back of this manual.
Curve setting examples
Pitch Trim (Hovering pitch, high pitch, low pitch)
The hovering pitch, low pitch, and high pitch trim setup screen can be called from the PIT Curve setup
screen.
● Return to Model Menu
● Hovering pitch
trim setting
● Low/High pitch trim
● Adjusts the adjusting dial.
(Continued on next page)
109