Futaba 14MZ - Manual (Page 58)

Frequency setting
The T14MZ transmitter uses a synthesizer
system. Its frequency can be changed within the
range of the frequency band of the module used.
The frequency of the R5014DPS receiver is set
from the transmitter. Use a receiver matched to the
frequency band of the transmitter.
Receiver ID code
When the R5014DPS receiver (PCM-G3
receiver) is used, the ID code located on the back
of the receiver case must be entered.
*When two receivers are used with a large model, etc., enter
the 2nd receiver ID also.
●Return to Linkage Menu
● Touch the [Frequency] button in the Linkage
Menu to call the setup screen shown below.
Frequency Frequency Band (frequency) setting, modulation mode setting, receiver ID code
setting.
Frequency switching method
For a description of the frequency switching and
ID setting methods, refer to the procedure given in
the Basic Operation section.
Modulation mode change
1. Touch the Modulation Mode button to call
the selection screen, and then touch the
button of the type of modulation used.
2. Touch the [Enter] button to switch the mode.
*When switching from the PCM-G3 mode to another mode,
the mode cannot be switched if the number of channels is
insuffi cient due to the wing type used.
3. After switching the modulation mode, turn
the transmitter power off and then switch the
mode by turning the transmitter power back
on.
Modulation mode selection
With the T14MZ, 3 modulation modes (PCM-G3/
PCM1024/PPM (FM)) can be selected. Select the
modulation mode matched to the type of receiver
used.
*After changing the modulation mode, switch the modulation
mode by turning the transmitter power off and on.
Receiver ID code input
1. Touch the receiver ID No. on the screen. The
receiver ID setup screen is displayed. Input
the 8-digit ID number displayed on the back
case of the receiver.
2. If the ID number is correct, touch the [Enter]
button. To correct the number, use the [BS]
button and change the number to the
correct ID code.
*Once the ID code is set, it does not have to be set again as
long as the receiver is not changed.
WARNING
When fl ying after frequency change, emit radio
waves only after verifying the frequency.
*Also change the frequency clip. Emitting radio waves with-
out verifi cation is extremely dangerous.
58