Futaba 14MZ - Manual (Page 113)

Acceleration Mixing
This function is used to adjust the pitch and
the throttle rise characteristic at acceleration/
deceleration operation. An acceleration function
which temporarily increases the pitch and throttle
operations at throttle stick acceleration/deceleration
operation can be set.
Example of acceleration function use
●When used at pitch, the Acceleration
function is effective when you want to
quicken the response of the fuselage at 3D
fl ight fl ip, etc.
When used, high pitch temporarily exceeds
maximum pitch, but immediately returns to
maximum pitch.
Using Acceleration with Pitch is effective when
you want to maximize speed for 3D aerobatics
and other aircraft responses. As an example, “ High
pitch” temporarily overrides “ maximum pitch” and
immediately returns to the maximum pitch position.
● Return to Model Menu
● Touch the [Acceleration] button in the Model
Menu to call the setup screen shown below.
● Pitch setting
●Operation point setting
● Throttle setting
Setting method
● Acceleration can be set at both setting at
acceleration (high) and setting at deceleration
(low).
(The operation point is displayed on a graph.)
● Acceleration rate setting (Rate)
● The return time after operation (Dumping) can be
set.
● The operation point at acceleration and
deceleration can be set. When an operation point
is exceeded, acceleration is performed.
Note: When using the Acceleration funtion, since the pitch
stroke is large, make your settings so there is no binding
of your linkage.
113