Futaba 14MZ - Manual (Page 103)

●Return to Model Menu
Motor [Corresponding model type]: EP glider, general
This function lets you set the operation speed
when the motor of a F5B or other EP glider is
started by switch. The operation speed can be set
in 2 ranges of slow speed flight and high speed
fl ight (Speed 1/Speed 2). This function can also be
operated as a safety function by setting 2 switches.
● The In side and Out side operating speeds can
be adjusted independently in 2 ranges (Speed
1/Speed 2).
● The boundary between the 2 ranges can be set.
(From Speed 1 to Speed 2)
● The set operation speed operation can be
activated at initial operation only. (1 time
operation) However, operation can be repeated
● Touch the [Motor] button in the Model Menu
to call the setup screen shown below.
● Move the cursor by set
switch or VR.
by setting the switch to OFF before operation is
fi nished. When you want to reset 1 time operation,
set the ACT button to [INH] and then reset it to
[ON].
● The motor (CH3) is controlled by SW-G. (Initial
setting) When changing the switch or stick which
controls the motor, fi rst change Function of the
Linkage Menu.
Note: When using this function, always check initial
operation with the propeller removed.
● Operation
Touch the button and set the function to ON.
● When you want to set the "One time mode",
touch the button and set the mode to [ON].
● Speed 1 to 2
The Speed 1 and Speed 2 region boundary
can be changed,
● Operation speed adjustment
The speed when Speed 1 and Speed 2 are
ON (In) and OFF (Out) can be adjusted.
● Operation
Touch the button and set the function to
ON.
● Group/single mode switching (Gr./Sngl)
(For more information, see the description
at the back of this manual.)
● Switch
A switch that turns the function itself
ON/OFF can be selected.
● Motor off
[Yes] and [No] are displayed by touching
the Motor Off button when [SW-G] is in
the motor OFF position. When [Yes] is
touched, the direction of the motor switch
is memorized. The screen graph display ON
direction also changes.
Notes
● First decide the motor OFF point, and then set the speed. When you want to
reset the motor OFF point, also reset the speed.
● We recommend that Motor OFF be set in combination with F/S.
● Set the basic operation direction with the Reverse function to match the
amp used.
● Always set the Motor OFF position.
103