Futaba 14MZ - Manual (Page 121)

Fine tuning VR setting
Mixing rate 0% at center of VR
When the VR is turned counterclockwise
and clockwise, the mixing rate increases
and decreases, respectively.
Mixing rate 0% at left end of VR
When the VR is turned, the mixing rate
increases.
Mixing rate 0% at right end of VR.
When the VR is turned, the mixing rate
increases.
When the VR is turned to the left or right
of the neutral position, the mixing rate
increases.
● VR selection ● Rate adjustment
● Operation mode selection
*Displayed at VR setting.
● Adjustment direction
setting
[Operation modes]
Common operations used in function setup screen
This section describes the functions often used at the function setup screen. Refer to it when setting each
function.
Group/single mode switching (Gr./Sngl)
W h e n s e t t i n g m u l t i p l e f l i g h t
conditions, linking the setting contents
with other conditions (Gr.) or setting
independently (Sngl) can be selected.
When the button is touched, it toggles
between Gr. and Sngl.
*Group mode (Gr.) (initial setting): The same
setting contents are set to all the flight
conditions in the group mode.
*Single mode (Sngl): Select this mode when
the setting contents are not linked with
other conditions.
*Selecting the single (Sngl) mode at each
condition after presetting in the group
mode (Gr.) is convenient.
Condition delay setting
Unnecessary fuselage motion generated when
there are sudden changes in the servo position and
variations in the operating time between channels
at condition switching can be suppressed.
When the delay function is set at the switching
destination condition, a delay corresponding to
that amount is applied and the related functions
change smoothly.
[Setting method]
1. Switch to the condition you want to set.
2. Touch the Delay button.
3. Use the adjustment buttons to set the delay.
*Initial value: 0
*Adjustment range: 0~25 (maximum delay)
Operations related to VR tuning Operations related to fl ight conditions
121