Futaba 14MZ - Manual (Page 27)

new frequency data is displayed. When
the frequency setting for the receiver is
completed, the LED monitor of the receiver
blinks once and the 1CH servo shuttles three
times across the neutral position.
*A very low power, whose frequency is different from that
of the channel frequency, is used to set the frequency of the
receiver. The reachable distance of the radio is designed to
be within several feet. Therefore, put the transmitter and the
receiver as close as possible when setting the frequency of
the receiver.
* If the receiver can not load the new data
due to environmental reasons, connect the
transmitter and the receiver directly by the
DSC cable. And do the procedure 6 and 7.
*LED monitor will blink on and off if the receiver's ID code
is wrong. Then move back to the Receiver ID Set screen and
restart the receiver's ID setting from the beginning.
7. Push the button "End" when the frequency
setting is completed. Then turn off the power
of the transmitter following the instructions
shown on the screen. You will be able to
use the new frequency after you turn on the
power again.
In case of using PCM1024, PPM receivers
*Make sure that PCM1024 or PPM is set as a modulation
scheme. Then change the frequency by the following
instruction.
How to change the frequency
1. Turn on the power of the transmitter.
2. Push the area that shows the frequency in
the home screen or push the "Frequency"
button in the Linkage menu. Then the
Frequency Set screen will pop up.
3. Push the "Band NO. (Frequency)" button if
you need to change the frequency. Then
you will see frequencies on the screen. Select
the frequency you want use. Push the button
"Yes" after confi rmation. Then you will see the
"Confi rmation of the change" box.
*If you have changed the module prior to turning on the
power, confi rmation screen will pop up to ask you whether
you want to change the frequency. Push the button "Yes" to
change the frequency.
4. If the frequency is correct, push the button
"Yes". Turn off the power of the transmitter
following the instructions shown on the
screen. You will be able to use the new
frequency after you turn on the power again.
Registration of the user's name
T14MZ transmitter can register user's name.
How to register user's name
1. Turn on the power of the transmitter.
2. Push the area of the user's name shown on
the home screen or the "user's name" in the
linkage menu. Then the User's Name Set
screen will pop up.
3. Push the user's name. Then the keyboard will
pop up. You can use up to 32 characters
as a user's name. Use the keyboard on the
screen to enter user's name.
4. Push "Return" key to return to the previous
screen after entering the user's name.
(If you want to protect the user's name)
If you don't want anybody else to change your
user's name, set your ID in the following way.
*Please be aware that you will not able to change user's name
if you forget your password.
1. Make sure that the security mode is "User's
name", and then push the User ID button.
2. Enter your password, using keyboard on the
screen.
You will need to enter your password for
changing the user's name from the next time
you turn on the power of the transmitter.
*Even if you enter the same character, your password will be
identified differently depending on whether you are using
"Transform" mode or "Direct" mode for inputting.
27
space key