FingerTec FRIS II - Manual (Page 37)

8
Server Information
– To show the informa-
tion of the FRIS in use.
Server IP: The IP address
of the FRIS server in use.
Zone: The zone, which
FRIS server belongs to.
Terminals: The total of
connected FingerTec ter-
minals to FRIS server.
Online Client: The total
of connected FRIS client
to FRIS server
Users: The total of users
inside FRIS server.
Logs : The total of trans-
action logs stored inside
FRIS server.
Fingerprints: The total
of fingerprint templates
stored in FRIS server.
Bad fingerprints: T h e
total of bad fingerprint
templates stored in FRIS
server.
User Information – Prompt to show information of user, during FRIS is verifying user’s fingerprints.
User ID: The user ID assigned to the user.
User Name: Name display on FingerTec terminals during verification.
Emp No: Employee ID of the user.
Dept: The department which user belongs to.
Section: The section which user belongs to.
Valid: Y – Yes, user is activated in FRIS server and ready to verify by FRIS server.N – No, user is de-acti-
vated in FRIS server and user cannot verify his fingerprint at any connected FingerTec terminals.
Issued: The date when user was added into FRIS server.
Online Client Information to
show information of all con-
nected FingerTec terminals
To show all captured
transaction logs of
all users.
To show the connection
status between FRIS server
and all connected FingerTec
terminals.
To show all operations
done in FRIS server.
7 • FRIS SERVER AND TRANSACTIONS MANAGEMENT
Start and Stop FRIS Services
When the FRIS server starts, it will not run automatically. You must order the FRIS server
to start the service before all connected FingerTec terminals can interact with it.
Click “Start service” to order the FRIS server to start its operations:
When the service starts, you will see the window change as shown below:
Here are the details of each portion,