FingerTec FRIS II - Manual (Page 11)

12
Step 11 Click “Execute” to start the configuration process.
Step 12 Click “Finish” to complete configuration of MySQL server.
Congratulations!
You have completed the MySQL server installation and configuration. Please continue with your FRIS server configurations.
Installation of FRIS Server
The FRIS server’s function is to connect to all FingerTec terminals, to carry out verification
process done at FingerTec terminals. You can install both MySQL database server and
FRIS server into the same server, to ease system handling.
We recommend 1 FRIS 2 server to support 5 FingerTec terminals.
If you are using more than 5 FingerTec terminals in a location, you need to have more
than 1 FRIS server to carry out operations. This is recommended to speed up the opera-
tion of the FRIS server. In this condition, it is good to install MySQL databases and FRIS
servers separately to ease the load of the servers.
To install a FRIS Server, follow the steps below,
Step 1 Open the folder SERVER from the CD. Click “FRIS v2.0.6 Setup.exe” icon to start
installation the process.
Step 2 Click “OK” to start the installation process for MySQL Connector ODBC .51
Step Process starts. Please wait for it to complete.
Step 4 Click “Next” to start to install the MySQL connector/ ODBC .51. This is to link up
your FRIS server to MySQL server.
Step 5 Choose “Typical” for most widely used installation. Click “Next” to proceed.