FingerTec FRIS II - Manual (Page 17)

18
Add New FingerTec Terminals
Step 1 Click on “Terminal Management” in the Main control panel.
Step 2 A new window will pop up. Click “Add” to start.
Step Enter an IP address and the ID of FingerTec terminal, and click Read Terminal
Details to connect to the FingerTec terminal.
Step 4 Terminal details are read from the terminal. Choose “Enable” to “Yes” to start to
use the FingerTec terminals. Ignore the “Server” and the “Zone” columns.
Step 5 Click “Save” to keep all settings.
Step 6 The FingerTec terminal is added into the FRIS server, and you can continue to
add, remove, or edit the information of the FingerTec terminal.
Removal of FingerTec Terminal
Step 1 Click on “Terminal Management” in the Main control panel.
Step 2 Select the FingerTec terminal to delete.
Step Click “Delete” to proceed.