3 setup procedure, Setup procedure – Toshiba SX 2000 User Manual

Page 47

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Chapt.1 System Configuration

1.4.3

Setup procedure

The following chart shows the setup procedure of the free ASCII mode.

Connect the S2T to the serial ASCII devlce(s) by RS-485

interface. Refer to section 1.4.4

Select the free ASCII mode by setting the SW resister,

Refer to section 1.4.5

Set the baudrate, parity, data bit length, and stop bit.

Refer to section 1.4.6

Refer to section 1.4.8 for communication (transmitting

and receiving messages)

Once writing into the EEPROM, the setting is effective

until change mode

Sequence Controller S2T