Procedure for removing – Toshiba SX 2000 User Manual
Page 146
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

■ Procedure for removing
(1) Turn off power of the S2T and external power supplied to I/O modules.
(2) Remove the cover of modules.
(3) Disconnect the cables from the modules.
4.3 Mounting the Modules
Expansion interface
Power supply module
Station module
S2T CPU without station bus
I/O modules
:Disconnect the expansion cables
:Disconnect the cables from terminal blocks
:Disconnect the communication cable, etc.
:Disconnect the cables from terminal blocks
or the removal terminal blocks
or the connectors
(4) Loosen the screw at the
top of module.
(5) Push the upper lock lever
of module by one hand,
and press the lower mark
of module by another hand.
B
(6) Remove the module
vertically against the base.
6F8C0926
1 29