Tablel-ssupplementary function for computer link, 2 system configuration, System configuration – Toshiba SX 2000 User Manual
Page 36
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
1.3 Computer link mode
Tablel-SSupplementary function for computer link
The following supplementary function are prepared for applying to various system
control using computer link function.
S2T
resister
Name
Function
SW038
Response delay mode on the
programmer port
(RS232C)
Setting value: 0-30
A response message is issued from the S2T after
(setting value *10) ms.
SW057
Response delay mode on the
LINK port (RS485)
Setting value: 0-30
A response message is issued from the S2T after
(setting value *10) ms.
1.3.2
System configuration
The following figure shows the system configuration using computer link function.
S2T, link port (RS-485), one-to-N configuration (N is max. 32) is available. If the
master computer has RS-232C interface only, the RS-232C/RS-485 converter (ADP-
6237B) can be used.
S2T, programmer port (RS-232C), one-to-one contiguration is available.
One-to-N configuration
(S2T: RS-485)
Master Computer
Max. 32
One-to-one configuration
(S2T : RS-232C)
Master Computer
S2T
RS-232C
(15 m max.)
6F8C0926
19