Kenwood UD-952 - Manual (Page 82)

Specifications
(For other countries)
FM Tuner section
f Tuning frequency range............................87.5 MHz ~ 108 MHz
Sensitivity (IHF)................................. 13.2 dBf (1.2 ^iV at 75 i2)
Signal to noise ratio at 1 kHz
MONO.................................................. 75 dB (65 dBf input)
STEREO...............................................68 dB (65 dBf input)
Selectivity (IHF ± 400 kHz).................................................. 50 dB
Stereo separation (IHF at 1 kHz)........................................ 40 dB
Frequency response..............30 Hz ~ 15 kHz + 0.5 dB, -3 dB
AM Tuner section
Tuning frequency range
9 kHz step............................................531 kHz ~ 1,602 kHz
10 kHz step.......................................... 530 kHz ~ 1,610 kHz
Usable sensitivity.....................................12 |iV / (500 |aV / m)
Signal to noise ratio............................................................ 48 dB
Pro Amplifier section
Total harmonic distortion
................... 0.006 % (SOURCE DIRECT, 1 kHz, 200 mV)
Input sensitivity / Impedance
MD / DAT, VIDEO, AV AUX........................ 200 mV / 47 kQ
MIC.................................................................1.3 mV/47
k a
N.B. circuit.............................................................. +8 dB (max.)
(60 Hz)
Output level / Impedance
MD / DAT, VIDEO....................................... 200 mV / 2.2 kiJ
VIDEO section
Input level / Impedance
VIDEO (composite)......................................... 1 Vp-p / 75
Input (VIDEO, AV AUX)
Output level / Impedance
VIDEO (composite)......................................... 1 Vp-p / 75 Q
Output (MONITOR OUT,VIDEO)
[General]
Dimensions...........................................W: 270 mm (10-5 / 8")
H : 104 mm (4-1 /8")
D :328 mm (12-15/16")
Weight (net)............................................................2.5 kg (5.5 lb)
Power amplifier section
Rated power output
STEREO MODE
. 80 W + 80 W (EIAJ, 6 Î2)
SURROUND MODE
FRONT......................................... 75 W + 75 W (EIAJ, 6 O)
CENTER.................................................... 10 W (EIAJ, 8 0)
REAR................................................ Total 6 W (EIAJ, 8 O)
Total harmonic distortion
............................0.02 % (1 kHz, 1/2 Rated power, 6 £1)
Frequency response
Signal to noise ratio
Input sensitivity / Impedance
20 Hz ~ 70 kHz, + 0 dB, - 1.0 dB
..........105 dB (IHF'66)
...............1.0 V/47 kO
Output level / Impedance
SUPER WOOFER PRE OUT........................... 2.0 V / 600 O
OMNI PRE OUT................................................2.2 V / 600 £2
Graphic equalizer section
Individual channel................................. 63 Hz, 160 Hz, 400 Hz,
1 kHz, 2.5 kHz, 6.3 kHz, 16 kHz
Equalizer characteristic variable range
....................................................................................± 10 dB
[General]
Power consumption........................................................... 200 W
Dimensions.............................................W: 270 mm (10-5 / 8")
H : 124 mm (4-7 / 8")
D : 320 mm (12-5 / 8")
Weight (net)..........................................................6.5 kg (14.3 lb)
I Note I KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice.
FortheU.S.A.
Note to CATV system installer:
This reminder is provided to call the CATV system installer's at­
tention to Article 820-40 of the NEC that provides guidelines for
proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the build­
ing, as close to the point of cable entry as practical.
ica