Kenwood UD-952 - Manual (Page 2)

Before applying power
Unpacking
A Caution: Read this page earefuiiy to ensure safe operation.
, Unpack the unit carefully and make sure that all accessories are put aside so they will not be lost.
Examine the unit for any possibility of shipping damage. If your unit is damaged or falls to operate, notify your dealer immediately. If your unit was
shipped to you directly, notify the shipping company without delay. Only the consignee (the person or company receiving the unit) can file a claim
against the carrier for shipping damage.
We recommend that you retain the original carton and packing materials for use should you transport or ship the unit in the future.
Before applying power
Units are designed for operation as follows.
U.S.A. and Canada..................................................................120 V only
U.K. and Australia...................................................................240 V only Europe (Except for U.K.)........................................................ 230 V only
*Other countries............................110-120/220^30-240 Vswitchable
For the United Kingdom
Factory fitted moulded mains plug
1. The mains plug contains a fuse. For replacement, use only a 13-Amp
ASTA-approved (BS1362) fuse.
2. The fuse cover must be refitted when replacing the fuse in the
moulded plug.
3. Do not cut off the mains plug from this equipment. If the plug fitted
is not suitable for the power points in your home or the cable is too
short to reach a power point, then obtain an appropriate safety
approved extension lead or adapter, or consult your dealer.
If nonetheless the mains plug is cut off, remove the fuse and
dispose of the plug immediately, to avoid a possible shock hazard
by inadvertent connection to the mains supply.
*AC voltage selection
The AC voltage selector switches Type A and Type B on the rear
panel are set to the voltage that prevails in the area to which the unit
is shipped. Before connecting the power cord to your AC outlet,
make sure that the setting position of these switches matche your
line voltage. If not, it must be set to your voltage in accordance with
the following direction.
Our warranty does not cover damage caused by excessive line
voltage due to improper setting of the AC voltage selector
switches.
Safety precautiom
WARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN
OR MOISTURE.
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER
(ORBACK).NOUSER-SERVICEABLEPARTSINSIDE,REFERSERVICINGTOQUALIFiED
SERVICE PERSONNEL.
A
THE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS
INTENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED "DANGEROUS VOLTAGE"
WITHIN THE PRODUCT'S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A
RISK OF ELECTRIC SHOCK TO PERSONS.
A
THE EXCLAMATION POINTWITHIN AN EQUILATERALTRIANGLE IS INTENDEDTO ALERTTHE USERTO
THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE
LITERATURE ACCOMPANYING THE APPLIANCE.