Kenwood UD-952 - Manual (Page 78)

Symptom Cause. ftomedy
Radio stations cannot be received. • The antennas have not been connected.
• A proper broadcasting band has not been
selected,
• The frequency of the station to be received
is not uned.
• Connect antennas, -[¿j]
• Select a band.
• Tune to the frequency of the desired sta­
tion.
Noise interferes. • Car ignition noise.
• Influence of an electric appliance.
• A TV set is installed near the system.
• Install the outdoor antenna in an apart po­
sition from the road.
• Switch the suspected electric appliance
OFF.
• Install the TV or the system at an increased
distance between them.
A station has been preset but it cannot be
received by pressing the numeric key. • The frequency of the preset station is not
tunable.
• The preset memory has been cleared be­
cause the power cord has been unplugged
for a long period.
• Preset stations with tunable frequencies.
• Preset stations again.
Cassette deck unit
.. Cause „. «»raeily ' T' 1™'
Sound cannot be produced by pressing the
play key or no operation occurs even when
an operation key is pressed. • The connections of cords are wrong.
• The head is dirty.
• The tape is wound too tight due to irregular
winding.
• A nonrecorded tape is played.
• Connect properly referring to "Connec­
tions".
• Clean the head referring to "Head mainte­
nance". •*■^2
• Try another tape.
• Play a recorded tape.
No operation occurs even when an opera­
tion key is pressed.
• The cassette holder is not closed completely.
• The operation key is pressed immediately
after closing the cassette holder.
• The operation key is pressed in less than 3
seconds after turning the power ON.
• A tape is not inserted in the unit.
• The tape is wound too tight due to irregular
winding.
• The tape is fully wound to one of the reels.
• Close the holder completely.
• Press operations keys in more than a few
seconds after closing the holder.
• Press operation keys after waiting for more
than 3 seconds.
• Insert a tape.
• Try another tape.
• Change the tape transport direction or re­
verse the tape insertion orientation.
The DPSS malfunctions. • The tape used is not suitable for DPSS, for
example the spaces between tunes may be
too short.
• Refer to "DPSS".
The OCRS does not function. • A recordable tape is not present in deck B.
• A disc is not present in the CD player.
• The disc is dirty.
• Insert a recordable tape in deck B and retry
operation.
• Place a disc in the CD player and retry op­
eration.
• Clean the disc, place it in the CD player and
retry operation. ->[ p ^
In dubbing, the tape stops at different
moments in ecks A and B. • This is due to the difference in the tape
length or characteristics of the mechanisms
of two cassette decks.
• Small time difference does not mean a
malfunction.
The cassette holder cannot be opened by
pressing the eject key. • The key is pressed during recording or play­
back.
• The microcomputer is malfunctioning due to
external noise.
• Press in stop mode.
• Unplug the power cord and plug it again.
Sound is husky or high frequencies are not
reproduced. • The head is dirty.
• The tape is stretched or shrunk.
• Clean the head referring to "Head mainte­
nance". -gg
• Try another tape.