Kenwood UD-952 - Manual (Page 21)

Volume display
Muting the sound temporarily
Remote control unit only
c 1
Blinks
I Press again to resume the original volume.
I Adjusting the ieft/right volume balance
Indicates the center.
I Indicates the balance setting.
Compensation of bass sound
N.B.CIRCUIT: Natural Bass CIRCUIT
Every time the button is pressed,
mode changes as follows.
WJ / / : (Weak effect)
WJ : (Strong effect)
WJ -- / : (Attenuated bass)
® Wi UFF ; (N.B. circuit disabled)
W.5
• Normally, set to the WJ OFF position.
• Adjust the control to obtain as natural bass sound a
To decrease Right volume jj^ j |j
Playing sound with higher purity
When the SOURCE DIRECT function is
switched ON, the played signal takes the sim­
plest path without passing through the balance
control circuitry and audio processing circuitry
such as the DSP, so the sound can be played
with an improved purity.
H I R E r T O R
• When the SOURCE DIRECT is ON, the SOURCE DIRECT indi­
cators on the front panel lights.
• Press the key again to cancel the SOURCE DIRECT.
To decrease Left volume
Input selection on the preamplifier/tuner unit and easy operation function
By simply changing the input source selection (CD, TUNER TAPE, etc.), the selected source component starts to play automatically. Inversely,
playing a source component switches the input selection of the preamplifier/tuner unit automatically.
These operations are also possible from the remote control unit. When the power of the system is turned ON, the source which has been played
the last time the power is turned OFF is played automatically (CD, TUNER, etc.).
* The easy operation function is deactivated during environmental sound play (with which different sounds are output through the main speakers
and optional omni speakers).
Preparation £9l