Kenwood UD-952 - Manual (Page 41)

Recording (Deck B only)
Preparations
m Load a cassette tape in the deck.
• Select the tape transport direction (-^
or^).
• Select (two-side recording) or
":zd;" (one- side recording).
• Select the Dolby NR mode.
• (Insert a disc in the CD player.)
If the DUAL SOUND key is ON and the "TAPE" is selected
as the SUB (OMNI) INPUT, recording is not possible.
Start auto recording level adjustment.
(D Play the contents to be recorded
(or receive the radio station to be
recorded).
® Blinks. Lights.
The equalizer and presence effects applied to the music are recorded
^together with the music sound.
Each press changes the inputs as follows.
■© LH
® TUNER (frequency display)
(D TflPE
® nH/SRJ
® i'lHEn
® ni' RUi( The source component to be
recorded should be displayed.
• When the CD is input is selected and if a disc has been set in the CD
player, its playback starts immediately.
• The bias adjustment consists of checking the characteristics of the
loaded tape and adjusting the deck to allow best-balanced record­
ing. The adjustment data are held in memory unless the power is
turned OFF or the door of deck B is opened, so it is not required to
re-adjust the bias in case of re- recording.
• The bias adjustment completes in approx. 45 seconds, after which
the deck enters the stop mode.
• To abort bias adjustment in the middle, press the ■ key.
• Even if the bias adjustment is not performed, there will be no trouble
in recording because a general bias has been set depending on the
Normal, Chrome or Metal type of tape.
• The recording level setting completes in approx. 20 seconds, after
which the deck enters the record-pause mode.
• If recording is started during the setting (while the CRLS indicator is
blinking), distorted sound may be recorded.
• If the CRLS key is pressed during the setting (while the indicator is
blinking), the setting is interrupted and the deck enters the record-
pause mode.
• If a non-recorded space of more than 5 seconds is detected after
the CRLS key is pressed, the recording level setting is aborted.
When recording a CD, if the track(s) to be recorded is se­
lected by pressing a disc selector key or numeric keys
without pressing the ■ key, the recording of the cassette
deck starts automaticallay. (Synchro recording)
• Recording starts.
• Recording stops automatically when the tape side(s) to be recorded
have been recorded.
• If the LINEAR ACOUSTIC CONTROL setting is changed during re­
cording with the DUAL SOUND ON, the recorded volume (or the
balance between the main and SUB-OMNI inputs) varies.