Kenwood UD-952 - Manual (Page 66)

Dolby Surround adjustment
When video (LD) software carrying miDotaY«j ^ mark
' is played, this mode provides the simiiar Dolby Sur­
round effect to movie theaters.
Preparations
• Be sure to set the center mode prop­
erly according to the arrangement of
the speakers in your system.
/ Set the Dolby Surround mode.
J .
2 Set the delay time.
^*'**^*
(D Adjust.
MULTI LEVEL CQMTHOL
1^3 To increase
To decrease '''
3 Adjust the volume balance.
© Press the TEST TONE key.
TKTT0N6
D Adjust so that the volumes of the
center and rear speakers are iden­
tical to the main speaker volume.
(1) Select the channel.
HEAR CEMTCH
j__j L__j Center speaker
...... ^
^ I^Tom
To decrease
) Stop the test tone.
In the DOLBY PRO LOGIC SURROUND mode, sound is not output
through the OMNI speakers (optional). Also, the DUAL SOUND
key is deactivated in this mode.
fit
P R O L O B
Center mode display
N D R M R i
Delay time display
ÌEi R PO"
I When the DELAY TIME key is pressed, the current delay time is
displayed. The delay time can be adjusted in 5 steps with the
MULTI LEVEL CONTROL keys.
I The delay time can be adjusted in the range from 16 to 29 ms.
I Once the delay time has been set, it is stored automatically in
memory and will not change until it is set again.
I Noise-like test tone moves across the speakers every 1.5 second.
NORMAL or WIDE BAND mode; In PHANTOM mode:
► © JEST L (Left) TEST L (Left)
JEET E (Center) ® TEST R (Right)
TESI R (Right) 1— ® TEST S (Surround)
- © TEST 5 (Surround)
• When one of the MULTI LEVEL CONTROL keys is pressed, the
current volume level is displayed. While the level is displayed, it
can be adjusted in 1 dB steps every time one of the keys is pressed.
• The volume level can be adjusted in the range from -30 to +10 dB.
• The center level is stored in memory as the common setting with
the DOLBY 3 STEREO mode.
I