Kenwood UD-952 - Manual (Page 20)

Sound adjustment functions
Power ON/OFF
Press the POWER key of the power amplifier/graphic equal­
izer unit.
STAND BY indicator
POWER
fr
Remote control u
• The power of the overall system can be turned ON/OFF by
pressing the POWER key of power amplifier/graphic equalizer
unit.
Adjusting the volume balance between main and
OMNI speakers (optional)
The balance between the main speaker vol­
ume and OMNI speaker volume can be var­
ied freely. This allows you to enjoy various
sounds according to the ambience of the
music being played or to your personal
taste.
• Press one of the LINEAR ACOUSTIC CON­
TROL keys to display the current balance set­
ting, Pressing the keys while the setting is
displayed will change the setting.
• Pressing and holding the MAIN or SUB-OMNI
key alone allows to play the sound through the
main or Omni speakers alone.
• Set the Volume controls of the omni speakers
to the center positions.
Enhanced bass entertainment with super woofer (op­
tional)
® Press the S.W.EFFECT key.
a ^TTT) b
Remote control unit
{Point remote control unit to the main system.)
(D Adjust the super woofer volume.
To increase volui
В
It can also be adjusted with
the volume control provided
on the super woofer.
(Point remote control
unit to the super woofer.)
I Once the super woofer volume has been set, it will increase or
decrease according to the VOLUME adjustment.
Listening through headphones
® Insert the headphone plug into the PHONES jack.
I The sounds from all speakers are cut off,
I The sound output through the OMNI speakers (optional) are
not reproduced through the headphones.
(|) Adjust the volume.
the jack.
0 to reduce the volume before removing the plug from
STAND BY mode of POWER switch
When the power cord is plugged into an AC outlet, the STAND BY indicator lights regardless of the power ON/OFF setting. This is because, even
when the power is set to OFF, a small amount of power is supplied to the system to back up the memory. This status is called the standby mode
of the system. While the STAND BY indicator is lit, the power can also be turned ON/OFF from the remote control unit.