Kenwood UD-952 - Manual (Page 80)

Specifications
(For U.K. and Europe)
\ FM Tuner section
i Tuning frequency range........................... 87.5 MHz ~ 108 MHz
Sensitivity (DIN at 75 Q )
MONO..........................................................I.OiaV/ 11.2dBf
Signal to noise ratio
(DIN weighted at 1 kHz, 65.2 dBf input)
MONO...............................................................................65 dB
STEREO........................................................................... 62 dB
Selectivity (DIN ± 300 kHz) ................................................. 64 dB
Stereo separation (DIN at 1 kHz).................. ...................... 40 dB
Frequency response..............30 Hz ~ 15 kHz + 0.5 dB, -3 dB
MW Tuner section
Tuning frequency range.............. ............ 531 kHz " 1,602 kHz
Usable sensitivity..................................... 12 ¡xV / (500 (xV / m)
Signal to noise ratio.............................................................. 48 dB
LW Tuner section
Tuning frequency range...............................153 kHz ~ 279 kHz
Usable sensitivity..................................................................22 |xV
Signal to noise ratio.............................................................. 45 dB
Pre Amplifier section
Total harmonic distortion
.................... 0.006 % (SOURCE DIRECT, 1 kHz, 200mV)
Input sensitivity / Impedance
MD / DAT, VIDEO, AV AUX........................ 200 mV / 47 k Q
MIC................................................................. 1.3 mV/47 k£2
N.B. circuit....................................................... .......+ 8 dB (max.)
(60 Hz)
Output level / Impedance
MD / DAT, VIDEO....................................... 200 mV / 2.2 kO
VIDEO section
Input level / Impedance
VIDEO (composite)......................................... 1 Vp-p / 75 Q
Input (VIDEO, AV AUX)
Output level / Impedance
VIDEO (composite)......................................... 1 Vp-p / 75 ¿ 1
Output (MONITOR OUT, VIDEO)
[General]
Dimensions.........................................W: 270 mm (10-5 / 8")
H : 104 mm (4-1/8")
D :328 mm (12-15/16")
Weight (net)............................................................2.5 kg (5.5 lb)
Power amplifier section
Rated power output
STEREO MODE
...................................................... 70 W + 70 W (DIN, 6 ii)
SURROUND MODE
FRONT.......................................... 70 W + 70 W (DIN, 6 Q)
CENTER...................................................... low (DIN, 8 £2)
REAR................................................. 3W + 3W(DIN,8Q)
Total harmonic distortion
............................0.02 % (1 kHz, 1 / 2 Rated power, 6 £2)
Frequency response
..................................... . 20 Hz ~ 70 kHz, + 0 dB, - 1.0 dB
Signal to noise ratio
...................................................................... 105 dB (IHF'66)
Input sensitivity / Impedance
.......................................................................... 1.0 V / 47 k£2
Output level / Impedance
SUPER WOOFER PRE OUT........................... 2.0 V / 600 £2
OMNI PRE OUT................................................2.2 V / 600 £2
Graphic equalizer section
Individual channel................................. 63 Hz, 160 Hz, 400 Hz,
1 kHz, 2.5 kHz, 6.3 kHz, 16 kHz
Equalizer characteristic variable range
................................................................................... ± 10 dB
[General]
Power consumption........................................................... 200 W
Dimensions.............................................W: 270 mm (10-5 / 8")
H :124 mm (4-7/8")
D : 320 mm (12-5 / 8")
Weight (net)......................................................... 6.5 kg (14.3 lb)
I Note I
KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed
without notice.
Strombrytarens POWER beredskapsläge
Indikatorn STAND BY tänds after nätkabelns anslutning till ett vägguttag,
oavsett strombrytarens POWER till/frànslag. Detta anger att en liten
rnangd ström leds till komponenten som stöd for minnesinnehéllet.
Detta läge kallas for beredskapsläget. Strömbrytaren pä fjarrkontrollen kan
användas för att s!à pà och av strömmen as länge indikatorn STAND BY
lyser.
Virtanäppäimen (POWER) valmiustila (STAND BY)
Kun laltteen verkkojohto on liitetty pistorasiaan, valmiustilan merkkivalo
syttyy riippumatta virtanäppäimen (POWER) asennosta (ON/OFF).
Merkkivalo osoittaa, että laitteessa on hieman virtaa muistin sisältöjen
ylläpitoa varten. Tätä tilaa kutsutaan valmiustilaksi. Kun valmiustilan
merkkivalo (STAND BY) palaa, laitteen virta voidaan kytkeä ja katkaista
kaukosäätimellä.
Afbrydertastens (POWER) STAND BY funktion
När apparatets stremledning er tilsluttet en stikkontakt, lyser STAND BY
indikatoren, uanset om der er taendt ved afbryderen pä apparatet eher ej. Det
angiver, at apparatet bliver forsynet med en ganske lille maengde ström til
opret-holdelse af hukommelsens indhold.
Denne funktion kaldes STAND BY. När STAND BY indikatoren er taendt, kan
strommen til apparatet släs til og fra med fjernsty-ringsenheden.
PÀ/A V-knappens Stand-by funksion
När stromledningen til dette anlegget er satt I en vekselstromskontakt, vii
STAND-BY indikatorlampen lyse enten PÄ/AV-knappen er pä-eller avsiätt.
Dette betyr at en viss mengde ström tilfores anlegget slik at innholdet i
minnet ikke gär tapt.
Denne funksjonen kalles Stand-by. När indikatorlampen for STAND-BY er
tent, kan strommen släs PÄ / AV fra fjernkontrollen.
Symptom ,, ... 'J. Rerrt'bdy
à Radio stations cannot be received. • The antennas have not been connected. • Connect antennas.
• A proper broadcasting band has not been • Select a band.
selected.
• The frequency of the station to be received • Tune to the frequency of the desired sta­
is not uned. tion.