Brother INTELLIFAX 600 - Manual (Page 33)

BASIC OPERATION
Making A Copy
The IntelliFAX600/650M can be used as a convenience
copier. Once you have unpacked and set up the machine, it’s
a good idea to make a trial copy to check that the machine is
working, before attempting to send and receive faxes.
After the IntelliFAX600/650M has been connected to the
power outlet and has warmed up, the date/time display will
appear when there is no document in the feeder.
C O P Y : P R E S S C O P Y
1
ALTERNATE |
F A X ; N O . & S T A R T
To make a copy, place the document you wish to copy,
face-down, in the document feeder, and feed it in gently until
you feel some resistance. You can copy any document up to
8.5 inches/216 mm wide (A4 size).
When the IntelliFAX600/650M detects the document, the
display will change from the date and time.
□ c
To prevent the document from skewing as it is fed, adjust the
paper guides to fit the width of the document.
- b- FINE
^ I-7 PHOTO
-O- S.FINE
C
The default setting for making copies is SUPER FINE.
If you are copying a photograph, press the RESOLUTION key
until both lamps are lit. If you are making several copies, some
with photographs, set the resolution page by page in I.TEMP.
SETTINGS, (see page 8-9.)
COPY
Press the COPY key.
C O P Y I N G
The display will indicate that the machine is copying, and the
document will be fed through the machine.
Note:
- When the copy has been printed, the automatic paper cutter
will cut the page from the paper roll,
- The machine cannot read text or images closer than 1/8" from
any edge of the document.
- Do not pull on the paper while copying is in progress. This
may ruin the copied image.
3-6