Brother INTELLIFAX 600 - Manual (Page 70)

SENDING FAXES
3. Speed'Dialing
Up to 10 speed-dial numbers on the IntelliFAXbOO and up to
40 speed-dial numbers on the IntelliFAX650M can be stored,
and recalled by dialing a two-digit speed dial code on the
keypad.
SPEED DIAL
o
To speed-dial, first press the speed-dial key. This tells the
IntelliFAX600/650M to expect a speed dial code instead of a
full-length, manually-dialed number.
S P E E D - D I A L ? #
3 ” © ' ©
S P E E D - D I A L ? # 0
S P E E D - D I A L ? # 0 5
SET
B R O T H E R B E L G I U M
You will be prompted to enter a speed-dial number.
Enter the two digit speed dial code.
Press the SET key.
After entering the code, the name of the destination will appear
on the display.
Information on storing one-touch and speed-dial numbers is
given in the section on AUTO DIALING, page 7-1.
After the number to be dialed has been entered by one of these
three methods, press the START key.
S E N D I N G
The IntelliFAX600/650M will dial the number and send the
fax.
Note:
- When sending automatically, a "CNG" tone is sent by your
unit. This is an important signal if the other end is using a F/T
switch or TAD interface.
8-2