Brother INTELLIFAX 600 - Manual (Page 73)

SENDING FAXES
Automatic And Manual Redialing
HEDIAUPAUSE
o
A W A I T I N G R E D I A L
If your call fails to be connected for any reason, you can redial
the number by pressing the REDIAL/PAUSE key.
If you don’t want to waste time re-trying a busy number, the
IntelliFAX600/650M can also redial the number automatically
if auto redial has been switched on when configuring the system
(see page 5^). The IntelliFAX600/650M will re-dial the
number three times at five-minute intervals before giving up.
In the interval between re-tries, AWAITING REDIAL is
displayed.
If you wish to stop auto redial, just press the STOP key.
Resolution
In order to transmit a document over the telephone network,
the IntelliFAX600/650M scans the document, line-by-line,
from top to bottom, in the same way as a television picture.
The scanned image is then sent to another fax machine as an
electrical signal, where it is printed out line by line to
reproduce a copy of the original document.
The smaller the distance between the scan lines, the better the
reproduction of the document. This is known as the
RESOLUTION of the fax machine.
The IntelliFAX600/650M has three resolution settings.
STANDARD is a resolution of 98 x 203 lines per inch.
FINE is a resolution of 196 x 203 lines per inch.
SUPERFINE is a resolution of 392 x 203 lines per inch.
There is also a special mode for photographs, which will be
described later.
When sending a fax or making a copy, the resolution can be
changed at any time before you press the START key or COPY
key.
It is set by pressing the RESOLUTION key (labelled
FINE-S.FINE-PHOTO) on the right of the control panel.
Standerd resolution is selected when both lamps are off. One of
the other resolution setting is selected when the appropriate lamp
is lit. Afer sending the fax, the resolution will revert to
STANDERD.
8-5