Cabletron Systems 2E43-51R - Manual (Page 94)

Chapter 5: Local Management
5-46 2E43-51/2E43-51R User’s Guide
5.14 HIGH SPEED INTERFACE CONFIGURATION
SCREEN
The High Speed Interface Configuration screen displays the types of
interfaces installed in ports 5 and 6, their current operating mode, and
indicates if the ports are linked. This screen also allows the user to enable
or disable Auto-Negotiation and set the Advertised Ability.
To access the High Speed Interface Configuration screen from the High
Speed Interface Configuration Menu screen, use the arrow keys to
highlight the FAST ETHERNET INTERFACES menu item and press
ENTER. The High Speed Interface Configuration
screen displays.
Figure 5-21 High Speed Interface Configuration Screen
NOTE
The High Speed Interface Configuration screen, Figure 5-21 ,
applies only to ports 5 and 6. This screen supports the
FE-100TX, FE-100FX, and FE-100F3 Fast Ethernet Interface
Modules that operate at 100 Mbps.
Firmware Revision: XX.XX.XX
High Speed Interface Configuration
2251-24
Device Name: 2E43-51
BOOTPROM Revision: XX.XX.XX
Port 5
FE-100TX
Link
100Base-TXFD
[Auto-Negotiation]
[100Base-TXFD] [Disabled]
RETURN
2E43-51 LOCAL MANAGEMENT
Event Message Line
SAVE
Port Type
Link Status
Current Oper. Mode
Desired Oper. Mode
Advertised Ability
Port 6
Unknown
N/A
[N/A]
[N/A]
[N/A]
EXIT