AERCO Innovation (G-10-1350 to G-11-0563) - Manual (Page 27)

Chapter 3 Innovation Series Water Heaters
GF-128
Operation USER MANUAL OMM-0079_0B
07/21/11 AERCO International, Inc.
· 100 Oritani Dr. · Blauvelt, NY 10913 · Ph: 800-526-0288
Page 27 of 200
CHAPTER 3. OPERATION
3.1 INTRODUCTION
The information in this Chapter provides a guide to the operation of the Innovation Water Heater using the
Control Panel mounted on the front of the unit. It is imperative that the initial startup of this unit be
performed by factory trained personnel. Operation prior to initial startup by factory trained personnel will
void the equipment warranty. In addition, the following WARNINGS and CAUTIONS must be observed at
all times.
CAUTION
All of the installation procedures in Chapter 2 must be completed before
attempting to start the unit.
WARNING
ELECTRICAL VOLTAGES IN THIS SYSTEM INCLUDE 120 AND 24 VOLTS AC.
IT MUST BE SERVICED ONLY BY FACTORY CERTIFIED SERVICE
TECHNICIANS
WARNING
DO NOT ATTEMPT TO DRY FIRE THE UNIT. STARTING THE UNIT
WITHOUT A FULL WATER LEVEL CAN SERIOUSLY DAMAGE THE UNIT AND
MAY RESULT IN INJURY TO PERSONNEL OR PROPERTY DAMAGE. THIS
SITUATION WILL VOID ANY WARRANTY.
3.2 CONTROL PANEL DESCRIPTION
The Innovation Control Panel shown in Figure 3-1 contains all of the controls, indicators and displays
necessary to operate, adjust and troubleshoot the Innovation Water Heater. These operating controls,
indicators and displays are listed and described in Table 3-1. Additional information on these items is
provided in the individual operating procedures provided in this Chapter.