Cub Cadet Yanmar 3TNV72 - Manual (Page 35)

SAFETY
3-20 TNV IDI Service Manual
Safety Precautions
CAUTION
Do not allow the honing tool to operate
in one position for any length of time.
Damage to the cylinder wall will occur.
Keep the tool in constant up-and-down
motion.
0000090en
CAUTION
Any part which is found defective as a
result of inspection or any part whose
measured value does not satisfy the
standard or limit must be replaced.
0000119en
CAUTION
Any part determined to not meet the
service standard or limit before the next
service, as determined from the state of
current rate of wear, should be replaced
even though the part currently meets the
service standard limit.
0000120en
CAUTION
Never use a steel wire brush to clean
fuel injectors. Damage to the nozzle and
other components is likely to result.
0000172en
CAUTION
• NEVER remove or attempt to remove
the tamper-proof devices from the
full-load fuel adjusting screw or the
high-speed throttle limit screw on the
fuel injection pump and governor
assembly. These adjustments have
been made at the factory to meet all
applicable emissions regulations and
then sealed.
• NEVER attempt to make any
adjustments to these sealed
adjustment screws. If adjustments are
required, they can be made only by a
qualified fuel injection shop that will
ensure the injection pump continues
to meet all applicable emissions
regulations and then replace the
tamper-proof seals.
• Tampering with or removing these
devices may void the “Yanmar Limited
Warranty.”
0000146en
CAUTION
The fuel return line is a one-piece
assembly. Use care not to bend or twist
the fuel return line.
0000171en
TNV_IDI_ServiceManual_(3TNV72 for YN only).book 20 ページ ２００７年１１月２９日 木曜日 午後２時５８分