Cub Cadet Yanmar 3TNV72 - Manual (Page 199)

COOLING SYSTEM
8-8 TNV IDI Service Manual
Engine Coolant Pump
6. Remove the engine coolant pump
(Figure 8-4, (4)). Discard the gasket.
7. Remove the thermostat cover (Figure 8-5, (1)).
Figure 8-5
8. Remove the thermostat (Figure 8-5, (2)).
Remove the temperature switch
(Figure 8-5, (3)) and gasket (Figure 8-5, (4)).
Discard the gasket.
Cleaning and Inspection
Temperature Switch
1. Check for proper operation of the temperature
switch. Connect a continuity light or ohmmeter
to the temperature switch. Connect one lead to
the terminal of the switch (Figure 8-6, (1)) and
the other lead to the metal portion of the switch
(Figure 8-6, (2)).
Figure 8-6
2. Place the temperature switch and an accurate
thermometer (Figure 8-6, (3)) in engine
coolant.
3. Slowly increase temperature of the fluid using
an external heat source.
4. The temperature switch is normal if the
continuity light or ohmmeter indicates continuity
when the fluid temperature reaches
225°F - 235°F (107°C - 113°C).
Thermostat
1. Check for proper operation of the thermostat.
Place the thermostat (Figure 8-7, (1)) and an
accurate thermometer (Figure 8-7, (2)) in warm
water.
Figure 8-7
2. Slowly increase temperature of the water using
an external heat source.
3. The thermostat is normal if it starts to open at
the temperature value stamped on the flange of
the thermostat, and fully opens as the
temperature of the water is increased.
Radiator Cap
1. Check for proper operation of the radiator cap.
Install the radiator cap (Figure 8-8, (1)) on a
cooling system tester.
(3)
(4)
(1)
(2)
0001959A
0000577A
(2)
(1)
(3)
(2)
(1)
0000577A
TNV_IDI_ServiceManual_(3TNV72 for YN only).book 8 ページ ２００７年１１月２９日 木曜日 午後２時５８分