Cub Cadet Yanmar 3TNV72 - Manual (Page 247)

ALTERNATOR
11-14 TNV IDI Service Manual
Alternator
9. Remove the stator assembly
(Figure 11-10, (1)) from the front frame
housing.
Figure 11-10
10. If it is necessary to replace the bearing
(Figure 11-10, (2)) in the front frame housing,
remove the four bolts (Figure 11-10, (3))
securing the plate (Figure 11-10, (4)) to the
front frame housing. Remove the plate. Use a
puller to remove the bearing. Discard the
bearing.
11. If it is necessary to replace the bearing
(Figure 11-11, (1)) in the rear frame housing,
use a puller to remove. Discard the bearing.
Remove the bearing cover (Figure 11-11, (2))
and two thrust washers (Figure 11-11, (3)).
Figure 11-11
Reassembly of Alternator
1. If removed, reinstall the two thrust washers
(Figure 11-12, (3)) and bearing cover
(Figure 11-12, (2)) in the rear frame housing.
Lubricate the outside diameter of a new bearing
(Figure 11-12, (1)). Press the bearing into the
rear frame housing.
Figure 11-12
2. If removed, lubricate the outside diameter of a
new front frame housing bearing. Press the
bearing (Figure 11-13, (2)) into the front frame
housing. Reinstall the plate (Figure 11-13, (4))
to the front housing. Tighten the four bolts
(Figure 11-13, (3)).
Figure 11-13
1
2
4
3
0000259A
1
2
3
0000260A
1
2
3
0000260A
1
2
4
3
0000259A
TNV_IDI_ServiceManual_(3TNV72 for YN only).book 14 ページ ２００７年１１月２９日 木曜日 午後２時５８分