Cub Cadet Yanmar 3TNV72 - Manual (Page 154)

ENGINE
TNV IDI Service Manual 6-55
Cylinder Block
Reassembly of Pistons
1. Select the parts needed to assemble the piston
and connecting rod for one cylinder.
2. If removed, install a new wrist pin bushing
(Figure 6-83, (7)) using a press and the
appropriate service tool. Be sure to align the oil
holes.
Figure 6-83
3. Reinstall one circlip (Figure 6-83, (5)) into the
piston. Ensure the circlip is securely seated in
the groove.
IMPORTANT
The piston and connecting rod must be
assembled with the correct orientation.
When correctly assembled, the piston
identification mark (Figure 6-84, (1))
stamped into the top of the piston will be on
the opposite side of the connecting rod as
the match marks (Figure 6-84, (3))
stamped into the connecting rod and
connecting rod cap. When reinstalled in the
cylinder, the embossed mark
(Figure 6-84, (2)) cast into the beam of
connecting rod will face the flywheel end of
the engine.
Note: The actual appearance of the match
marks will vary but they will always be in
the same locations.
Figure 6-84
4. Place the connecting rod into the piston. The
match marks (Figure 6-85, (4)) on the
connecting rod and cap must be on the
opposite side as the piston identification mark
(Figure 6-85, (2)) on the top of the piston.
0001705A
(3)
(4)
(6)
(7)
(5)
(2)
(1)
(8)
(9)
(5)
CHC
H
MSM
S
(1)
0002464
0002090
E106 R
(2)
80 80
0002089
(3)
TNV_IDI_ServiceManual_(3TNV72 for YN only).book 55 ページ ２００７年１１月２９日 木曜日 午後２時５８分