Recording paper installation – Panasonic KX-F220 User Manual
Page 114
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

RECORDING PAPER INSTALLATION
Follow the steps below to install the recording paper.
• Replace the recording paper roll either the red end mark appears on the both sides of the paper, or the LC
Display shows “OUT OF PAPER". (Note: The end mark will not appear on some recording paper rolls)
•The unit will stop receiving or copying when the LC Display shows:
MON DEC25 7:30PM 00
OUT OF PAPER
CAUTION: You should only use Panasonic recording paper (KX-A102) as the print quality may otherwise
be reduced or excessive thermal head wear may occur.
Slide BACK LID Lever in the direction of the arrow to open the cover.
Insert a roll of recording paper into the paper compartment so that it may be tightly rolled, without any slack.
(Make sure that the shiny side of the paper is facing up.)
Caution:
•Make sure that a roll is correctly
installed. If it is reversed, no message
will be recorded.
Slack