Troubleshooting guide, Lc display, Cause & remedy – Panasonic KX-F220 User Manual
Page 110
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

TROUBLESHOOTING GUIDE
LC DISPLAY
THU JUN 15 3:00PM 00
*** CHECK COVER
CAUSE & REMEDY
The paper cover is open, close it.
THU JUN 15 3:00PM 00
CHECK DOCUMENT
Document is not properly fed. Re-insert the document again.
THU JUN 15 3:00PM 00
CHECK ICM TAPE
•Tape is broken or is not installed. Install a new one. (When replace the
tape, record your OGM.)
•Tape is full. Reset it or use 2-side of the tape.
THU JUN
15 3:00PM 00
CHECK MEMORY
The memory (phone numbers, parameters etc.) is erased. Reprogram
them.
THU JUN 15 3:00PM 00
+
RECORD OGM +***
OGM is not recorded. Record your OGM.
THU JUN 15 3:00PM 00
+ OUT OF PAPER ***
The recording paper roll is empty or recording paper is
(almost) finished, replace it.
THU JUN 15 3:00PM 00
PAPER JAMMED
•The recording paper is jammed, re-install it.
•Make sure that the recording paper has no slack.
THU JUN 15 3:00PM
00
POLLING ERROR
* UNIT OVERHEATED, *
PLEASE WAIT
• Polling password does not match. Set the same password as the other
unit has.
•The polled unit is not being programmed for polled setting.
•Polling function may be performed between KX-F220’s which have the
same protocol if polling password is set.
The unit may overheat. Leave the unit as it is and allow the unit to cool.
4-1