DVR systems WatchNET Software User Manual
Page 49
NDVR Server Manual
49
auto display in the client software. But user must be sure that client is running
on that IP address.
Note:
Alarm auto connection to IP is used to input alarm automatically. When
sensor, normal or motion record is set to input and there is IP address, the
system will check if the client has connected with this system. If there is no
connection, the system will try to connect with it through Port 5300(preset).
While it cannot be connected, the system will keep trying till the connection is
OK. So please ensure that your client’s program is in use, Port 5300 is
listening and the network is in good condition. If not so, the system will not be
stable.
【Alarm Send Port】This is the alarm message connecting port, which is
used to send alarm from NDVR Server to Client.
connecting port. Default value is 80 for
http access; but for some windows XP edition, it shields 80 ports. In this case,
user should modify this port to other port, such as 1280. After that, user must
reboot NDVR server, then user can access NDVR server via IE Client like this:
http://IP: 1280 (IP can be a static IP or dynamic domain name).
【Use DNS】Select use DNS or not, support dynamic IP.
【Local Host Name】Input the name description for DNS Server
identification.
【DNS Server IP】DNS server host IP.
【DNS Connection Port】DNS server host port ,it is used to connect DNS
server.
DNS server work mode:
If it is required, please get DNS server software from developer.