DVR systems WatchNET Software - Manual (Page 31)

NDVR Server Manual
31
By default, the entire screen is set as motion detection area where is
indicated with green border around the image. To mask a specific area, you
can click button to cancel the full screen detection border; then
Left-Single-Click and drag a rectangle. A green rectangle will mark the area of
it. Also, you can set any other areas. Any activities in the motion detection
areas will trigger recording, depending on the reaction mode; and alarms may
be generated along with electronic map icons flashing in alert mode. Click
button to test the sensitivity of motion detection. The sensitivity
can be adjusted by dragging the slider bars below the motion detection
window,
The Sensitivity value bar is used to adjust the sensitivity of the area you
selected. The sensitivity value is smaller the motion detection is more
sensitive.