DVR systems WatchNET Software - Manual (Page 44)

NDVR Server Manual
44
This panel includes matrix group and display group. Each group includes
16 numeric buttons; each button denotes one type of matrix or display. This
will describe in Digital matrix setup .
1.4.9 Sensors / Relays Control
1. Sensor Control
Press number button to check sensor all time forcibly
even though user didn ’t set check sensor in sensor setup . The
channel of DI and DO is determined by the setup of DI/DO
device you set in System setup . There are two types of status
to DI:
Input channel 2
doesn’t check sensor forcibly.
Input channel 3 checks sensor forcibly or has an alarm
inputting.
When there is no alarm yet, user can press number
button to check sensor forcibly. Press the button again to stop
checking all time, then system checks sensor according to
Sensor setup . When there is an alarm, the corresponding
button will show the alarm with green.
Note:
When you select WT-E-7632-RI and the combination is not the standard
configuration (combination of WT-E-7608-RI and WT-E-7616-RI or
WT-E-7608-RI: total DI is less than 32), some ports are not available according
to the setting of decoder address. For example: user selects WT-E-7632-RI
and the combination is WT-E-7608-RI (decoder address is 1) and
WT-E-7616-RI (decoder address is 2), then the Sensors ports 9 to 16 are not
available, so that the status indication is not available.
2. Relay Control
Press number to open/close alarm device relay switch manually. There
are two types of status to DO:
Output channel 2 is close.
Output channel 3 is open.