DVR systems WatchNET Software - Manual (Page 139)

NDVR Server Manual
139
【Periodical Recording】Select On when you want to use periodical
recording.
【Periodical Mode】Select the periodical recording mode.
Periodical mode: An image file is recorded periodically according to the
specified Interval and Effective period.
Tour mode: An image file is recorded when the camera is moved to each
preset position during the tour.
Note:
You cannot record files in Tour mode while PTZ on motion detection is
performed.
【Periodical Interval】Type the interval at which you want to record an
image in the memory periodically. You can set the hour (H), minutes (M) and
seconds (S) between 1 second and 24 hours (one day).The actual interval
may be longer than the set value depending on the image size, image quality,
bit rate, or recording media.
Motion
【Threshold setting slider bar】Set the threshold level of motion
detection that is common to all the windows. The threshold level is used to
judge whether or not there has been any motion in the camera image. When
the motion of an object on the monitor screen has exceeded the threshold
level, the camera judges that there has been a motion and a green frame is
shown. An alarm is output when a green frame is added to the object displayed
in one of the active windows.
【Object size】Select the minimum size of a detectable object. Select the
minimum size of a detectable object from L (Large), M (Medium) and S
(Small). Each option represents the corresponding size below:
L: 64 × 64 dots
M: 32 × 32 dots
S: 16 × 16 dots