Compaq AA-Q88CE-TE - Manual (Page 80)

CALL RTR_ACCEPT_TX
Qualifiers
/CHANNEL_NAME=channel_name
/CHANNEL_NAME=RTR$DEFAULT_CHANNEL
Specifies the channel for which the operation is to be performed.
The command server uses a combination of the channel_name and the window
from which the call was issued to uniquely identify which channel to use.
channel_name is not case sensitive.
The default channel name is RTR$DEFAULT_CHANNEL.
/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither /NODE nor /CLUSTER is specified then the command is executed on the
nodes specified by the latest SET ENVIRONMENT command. If no SET ENVIRONMENT
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/FORGET
/NOFORGET
Use /FORGET to specify the flags parameter as RTR_F_ACC_FORGET in the
call rtr_accept_tx( ) .
The default for value for /FORGET is /NOFORGET, which causes the command
server to use the value RTR_NO_FLAGS for the
flags parameter in the call to
rtr_accept_tx( ) .
/INDEPENDENT
NOINDEPENDENT
Use the /INDEPENDENT qualifier to specify the flags parameter RTR_F_ACC_
INDEPENDENT in the call to rtr_accept_txt( ).
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in node-list . If
node-list is omitted then the command is executed only on the node where the
command was issued.
/OUTPUT[=file-spec]
/OUTPUT=stdout (D)
Specifies that the resulting information is written to the file file-spec . If
/OUTPUT or file-spec is omitted then the standard or default output is used.
/REASON[=reason]
/REASON=0
Use /REASON to supply a value for the reason parameter in the call to
rtr_accept_tx( ) .
The default for value for /REASON is 0, which causes the command server
to use the value RTR_NO_REASON for the
reason parameter in the call to
rtr_accept_tx( ) .
6–4 RTR Command Line Interface