Compaq AA-Q88CE-TE - Manual (Page 226)

SHOW NODE
SHOW NODE
Shows the node network status, the autoisolation state and the node inactivity
timer.
Format
SHOW NODE
Command Qualifiers Defaults
/CLUSTER /NOCLUSTER
/NODE[=node-list] /NODE=default-node-list
/OUTPUT[=file-spec] /OUTPUT=stdout
Description
The SHOW NODE shows the network status, the autoisolation state (enabled or
disabled) and the node inactivity timer.
Qualifiers
/CLUSTER
/NOCLUSTER (D)
Specifies that the command is executed on all the nodes in the cluster.
If neither /NODE nor /CLUSTER is specified then the command is executed on the
nodes specified by the latest SET ENVIRONMENT command. If no SET ENVIRONMENT
command has been entered then the command is executed only on the node where
the command was issued.
Note: In environments that do not support clustering, use of the /CLUSTER
qualifier will cause the relevant command to be executed on the local node only.
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in node-list . If
node-list is omitted then the command is executed only on the node where the
command was issued.
/OUTPUT[=file-spec]
/OUTPUT=stdout (D)
Specifies that the resulting information is written to the file file-spec . If
/OUTPUT or file-spec is omitted then the standard or default output is used.
Related Commands
• SET NODE/ISOLATE
• SET LINK
6–150 RTR Command Line Interface