Compaq AA-Q88CE-TE - Manual (Page 195)

SET MODE
/NODE[=node-list]
/NODE=default-node-list (D)
Specifies that the command is executed on all nodes specified in node-list . If
node-list is omitted then the command is executed only on the node where the
command was issued.
/OUTPUT[=file-spec]
/OUTPUT=stdout (D)
Specifies that the resulting information is written to the file file-spec . If
/OUTPUT or file-spec is omitted then the standard or default output is used.
Related Commands
• SHOW MODE
Examples
RTR> SET MODE/GROUP
This command tells RTR to enter GROUP mode.
RTR> SET MODE/NOGROUP
This command tells RTR to enter NOGROUP mode.
RTR Command Line Interface 6–119