Compaq AA-Q88CE-TE - Manual (Page 184)

SET ENVIRONMENT
SET ENVIRONMENT
Specify the node(s) where subsequent RTR commands are executed.
Format
SET ENVIRONMENT
Command Qualifiers Defaults
/CLUSTER /NOCLUSTER
/NODE=node-list /NODE=this_node
Description
The SET ENVIRONMENT command causes subsequent RTR commands to be executed
on the specified nodes. Entering SET ENVIRONMENT without any qualifiers causes
subsequent RTR commands to be executed on the local node only.
Qualifiers
/CLUSTER
Currently only fully supported in an OpenVMS environment, in which case
it specifies that subsequent RTR commands are executed on all nodes in the
VMScluster.
For other implementations, using /CLUSTER is interpreted as /NODE=this_node
/NODE[=node-list]
Specifies that subsequent RTR commands are executed on all nodes specified in
node-list . If node-list is omitted or both the /NODE and /CLUSTER qualifiers are
omitted then subsequent commands are executed on only the local node.
Related Commands
• SHOW ENVIRONMENT
Examples
See Section 1.5, Remote Commands, for examples of how to use the SET
ENVIRONMENT command.
6–108 RTR Command Line Interface